Stream your service: NDI, SDI or go live directly
Three ways to get your service out of the building: NDI over the network, SDI out of a Blackmagic card, or Direct Live straight to YouTube and Facebook.
On this page
ChristChant can send its screens out in three ways, and you can use them at the same time. Pick the ones that match the equipment you already have.
| Way out | Best for | Needs |
|---|---|---|
| NDI | A stream computer running OBS, vMix or a network switcher. | A wired network. |
| SDI | A hardware video switcher that takes a cable. | A Blackmagic DeckLink or UltraStudio device. |
| Direct Live | Going online with no extra computer or software. | A stream key and a good upload connection. |
NDI: every screen is a source
NDI publishes each screen you choose as a named source on your network. In OBS, vMix or another NDI switcher, add an NDI source and pick it by name.
- Open Settings, then Network & Streaming.
- Under NDI Screen Sources, enable the screens you want to publish.
- Set a Source name prefix. Each screen name is added to it, so every source has its own name.
- Choose a Frame rate under Output Provider. It applies to NDI and Direct Live.
You can also turn NDI on or off from the Provider tab of the Master panel, using the NDI chip. Sound is set separately: see Choose what sound each NDI source carries.
SDI: a cable into the switcher
Play a screen out of a Blackmagic port, with embedded audio and fill-and-key. See Send a screen out over SDI with a Blackmagic card.
Direct Live: no extra computer
Direct Live sends the Broadcast screen to YouTube, Facebook or any RTMP server. It lives in the Provider tab of the Master panel, under the Broadcast screen.
- Turn the Broadcast screen on if it is off.
- In the Provider tab, set up your destination and paste your stream key.
- Choose your quality, then press Go Live. Press it again to stop.
Everything about the destination, quality and sound mix is in the Broadcast Studio: see Broadcast Studio: quality, sound mixer and stream health. To send to several platforms at once, see Stream to YouTube, Facebook and more at the same time.
Was this helpful?
Your answer helps us improve this guide.
More in Streaming & cameras
- Your camera, in the room and on the streamConnect a USB camera, an IP camera or a phone, cut between cameras with one key, put the camera behind any slide on your projector, and give your live stream a camera layout with the lyrics and your church logo on top.
- Put a live camera on your screensAdd a camera, show its picture behind or in front of your lyrics, choose which screens display it, and switch between cameras smoothly.
- Record your service with chaptersSave every song, reading and the sermon as one video on this computer, with chapters you can jump to, a chapter list for YouTube, and the sermon as audio for a podcast.
- Send a screen out over SDI with a Blackmagic cardPlay any screen out of a Blackmagic DeckLink or UltraStudio port, with embedded audio and fill-and-key for a switcher.