Launch Special: 20% OFF All Products!

Ends Nov 30, 7:19 PM PHT

Per DTI Fair Trade Permit No. 8442440, Series of 2026

Going live

Run several channels at once

Songs, scripture, slides and video each have their own channel. Keep several live, switch which one is on the screens, and control one while another stays on air.

Last checked 3 min read
On this page
  1. The channels
  2. A tab for every live channel
  3. Control one while another stays on air
  4. Switch the program

A service mixes things: a song, then a reading, then the sermon slides, with an announcement loop in the lobby. ChristChant gives each kind of content its own channel, with its own Preview and its own live state, so preparing one never disturbs another.

Watch: Run several channels at once (about 3 minutes)

The channels

The rail beside the Preview switches between channels.
ChannelHolds
SongLyrics from your song library.
Sermons, Announcements, Lobby, TimerFour independent slide channels (A to D) for presentations, PowerPoint decks, countdowns and loops. See Use the four slide channels.
BibleScripture passages.
VideoVideo clips.
ImagePictures and slideshows.

A tab for every live channel

Every channel you feed gets a tab at the top of the Live Controller. The one on the screens is marked PGM (the program); the others wait in standby, ready to switch to.

PGM marks the channel on the screens; its dot pulses. Each dot wears its channel's colour.

Control one while another stays on air

Click a tab that isn't the program to work with it, such as moving to the right verse, while the program stays on the screens. The note at the top right says what you're controlling, and that it's not the program.

Getting the reading ready while the song is still on the screens.

Switch the program

Under the room monitor, a row of buttons lists the channels on the live bus. Click one to put it on the screens. You can also do it from Pipeline Flow with To Program.

How do I take a channel off the live bus?

Click Drop on its card in Pipeline Flow. In its Preview, the Fed button does the same.

Can a channel go to one screen only?

Yes. An extra screen can show a single channel on its own, such as a lobby screen showing the Lobby channel all service long. See Add more screens.

Was this helpful?

Your answer helps us improve this guide.